ThreatFortress MDM Deployment

If you have any questions or need help, please connect with the ChatFortress Support team at [email protected] or you can use the Secure Wire Chat with your team. 

The process to complete your ThreatFortress MDM install is as follows: 

  1. Submit your device cell phone number or email address to [email protected]
  2. Open the ThreatFortress Miradore Invitation 
  3. Complete the Profile Installation
  4. Confirm with ThreatFortress SOC team sensor active. 

iOS install. 

This is the same process for cell phones or tablets. The process is the same as iPhones and Tablets. 

NOTE: Please use Safari to download the file.

  1. You will receive an email or SMS with an invitation to install the profile on your device. 

This email or SMS will provide you with a URL to click on along with the username and password that is required. 

2. Click on the URL provided. This will send you to a page that downloads the profile to your device to allow us to complete the install.

3. Click on Settings > Profile Downloaded and proceed to install the profile that has been downloaded.

4.  Click the install button top right. 5. This will then proceed to download the files and complete the installation. You may need to click the install button again like this. 6. This will then ask you to confirm the install of the file on the screen below.       7. Once complete it will show a screen like this with a “Done” button in the top right.

If you have any questions or issues please connect with our support team. 


Do I need to complete this on each device?
Yes, you will need to complete these steps on each device. Should take you less than 60 seconds if you are on wifi. 

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us